Cisco Systems 2984G Manual De Usuario
3-17
Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide
78-6286-05
Chapter 3 Installing the Switch
Installing the Catalyst 2948G-GE-TX Switch
Attaching the RPS Connector Cover
If you are not using a Cisco RPS with your switch, use the two Phillips pan-head
screws to attach the RPS connector cover to the back of the switch before you
mount it, as shown in
screws to attach the RPS connector cover to the back of the switch before you
mount it, as shown in
.
Warning
If an RPS is not connected to the switch, install an RPS connector cover on the
back of the switch. Statement 265
back of the switch. Statement 265
Figure 3-13 Attaching the RPS Connector Cover on the Catalyst 2948G-GE-TX
Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached
securely to wall studs or to a firmly attached plywood mounting backboard.
Mount the switch with the front panel facing up, as shown in
securely to wall studs or to a firmly attached plywood mounting backboard.
Mount the switch with the front panel facing up, as shown in
1
Phillips pan-head screws
3
RPS connector
2
RPS connector cover
1
2
RATING
100-200V ~
1.6A-0>9A, 50-60 H
Z
DC IN
PUTS FO
R REM
OTE
POWER SUPPL
Y
SPECIFIED
IN MANU
AL
+12v @
8.5a
98668
3