Cisco Systems 3560 Manual De Usuario
4-19
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 4 Configuring Cisco EnergyWise
Additional Information
Figure 4-5
EnergyWise with IP Routing
On Switch 1, to prevent a disjointed domain, manually assign Switch 2 as a static neighbor or the reverse.
Switch(config)# energywise neighbor 192.168.2.2 43440
Switch 1 discovers Switch 3 as a neighbor because they are in the same LAN.
On Switch 1, verify neighbor discovery.
Switch# show energywise neighbors
Capability Codes: R-Router, T-Trans Bridge, B-Source Route Bridge
S-Switch, H-Host, I-IGMP, r-Repeater, P-Phone
Id Neighbor Name Ip:Port Prot Capability
-- ------------- ------- ---- ----------
6 Switch-2 192.168.2.2:43440 static S I
9 Switch-3 192.168.1.3:43440 cdp S I
Switch 1 uses both static and dynamic protocols to detect neighbors.
Verify that switches are in the same domain:
Switch# energywise query name * collect usage
EnergyWise query, timeout is 3 seconds:
Host Name Usage
---- ---- -----
192.168.1.2 Switch-1 96.0 (W)
192.168.40.2 shipping.1 6.3 (W)
192.168.40.2 guest.1 10.3 (W)
192.168.50.2 shipping.2 8.5 (W)
192.168.50.2 lobby.1 10.3 (W)
Queried: 72 Responded: 72 Time: 0.65 second
In a routed network, a switch port assigned to a VLAN can be connected to a router interface. The IP
address of the VLAN SVI is 192.168.1.2, and the IP address of the router interface is 192.168.1.1.
address of the VLAN SVI is 192.168.1.2, and the IP address of the router interface is 192.168.1.1.
Configure the domain:
Switch(config)# energywise domain cisco secret 0 cisco protocol udp port 43440 ip
192.168.1.2
Switch 1
Switch 3
192.168.1.3
LAN 10
192.168.1.2
Port 1
192.168.1.1/24
Port 24
192.168.2.1/24
192.168.2.1/24
Port 24
Switch 2
Port 1
192.168.2.2
205695
LAN 20
Router A