Cisco Systems 3560 Manual De Usuario
10-62
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 10 Configuring IEEE 802.1x Port-Based Authentication
Configuring 802.1x Authentication
This example shows how to configure 802.1x authentication with web authentication as a fallback
method.
method.
Switch(config) configure terminal
Switch(config)# ip admission name rule1 proxy http
Switch(config)# fallback profile fallback1
Switch(config-fallback-profile)# ip access-group default-policy in
Switch(config-fallback-profile)# ip admission rule1
Switch(config-fallback-profile)# exit
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# switchport mode access
Switch(config-if)# dot1x port-control auto
Switch(config-if)# dot1x fallback fallback1
Switch(config-if)# end
For more information about the authentication fallback and dot1x fallback commands, see the
command reference for this release. For more information about the ip admission name and ip
access-group commands, see the
command reference for this release. For more information about the ip admission name and ip
access-group commands, see the
Cisco.com.
Step 9
authentication port-control auto
or
dot1x port-control auto
Enable 802.1x authentication on the interface.
Step 10
authentication fallback fallback-profile
or
dot1x fallback fallback-profile
Configure the port to authenticate a client by using web
authentication when no 802.1x supplicant is detected on the port.
Any change to the fallback-profile global configuration takes effect
the next time 802.1x fallback is invoked on the interface.
authentication when no 802.1x supplicant is detected on the port.
Any change to the fallback-profile global configuration takes effect
the next time 802.1x fallback is invoked on the interface.
Note
Web authorization cannot be used as a fallback method
for 802.1x if the port is configured for multidomain
authentication.
for 802.1x if the port is configured for multidomain
authentication.
Step 11
exit
Return to privileged EXEC mode.
Step 12
show authentication interface interface-id
or
show dot1x interface interface-id
Verify your configuration.
Step 13
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose