Cisco Systems 3560 Manual De Usuario

gigabitethernet module/{first port} - {last port}, where the module is always 0

port-channel port-channel-number - port-channel-number, where the port-channel-number 
is 1 to 48.

When you use the interface ranges with port channels, the first and last port-channel 
number must be active port channels.

You must add a space between the first interface number and the hyphen when entering an 
interface-range. For example, gigabitethernet0/1 - 4 is a valid range; gigabitethernet0/1-4 is not 
a valid range.

The VLAN interfaces must have been configured with the interface vlan command. The show 
running-config privileged EXEC command displays the configured VLAN interfaces. VLAN 
interfaces not displayed by the show running-config command cannot be used as interface-ranges. 

All interfaces defined as in a range must be the same type (all Fast Ethernet ports, all Gigabit 
Ethernet ports, all EtherChannel ports, or all VLANs), but you can combine multiple interface types 
in a macro.

This example shows how to define an interface-range named enet_list to include ports 1 and 2 and to 
verify the macro configuration:

Switch# configure terminal

Switch(config)# define interface-range enet_list gigabitethernet0/1 - 2

Switch(config)# end

Switch# show running-config | include define 

Switch# define interface-range enet_list gigabitethernet0/1 - 2

This example shows how to create a multiple-interface macro named macro1:

Switch# configure terminal

Switch(config)# define interface-range macro1 fastethernet0/1 - 2, gigabitethernet0/1 - 2

Switch(config)# end

This example shows how to enter interface-range configuration mode for the interface-range 
macro enet_list:

Switch# configure terminal

Switch(config)# interface range macro enet_list 

Switch(config-if-range)# 

This example shows how to delete the interface-range macro enet_list and to verify that it was deleted.

Switch# configure terminal

Switch(config)# no define interface-range enet_list 

Switch(config)# end

Switch# show run | include define

Switch# 

These sections contain this configuration information: