Cisco Systems 3560 Manual De Usuario
C H A P T E R
36-1
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
36
Configuring IP Unicast Routing
This chapter describes how to configure IP Version 4 (IPv4) unicast routing on the Catalyst 3560 switch.
Basic routing functions, including static routing and the Routing Information Protocol (RIP), are
available with both the IP base image (formerly known as the standard multilayer image [SMI]) and the
IP services image (formerly known as the enhanced multilayer image [EMI]). To use advanced routing
features and other routing protocols, you must have the IP services image installed on the switch.
Basic routing functions, including static routing and the Routing Information Protocol (RIP), are
available with both the IP base image (formerly known as the standard multilayer image [SMI]) and the
IP services image (formerly known as the enhanced multilayer image [EMI]). To use advanced routing
features and other routing protocols, you must have the IP services image installed on the switch.
Note
If the switch is running the IP services image, you can also enable IP Version 6 (IPv6) unicast routing
and configure interfaces to forward IPv6 traffic in addition to IPv4 traffic. For information about
configuring IPv6 on the switch, see
and configure interfaces to forward IPv6 traffic in addition to IPv4 traffic. For information about
configuring IPv6 on the switch, see
For more detailed IP unicast configuration information, see the Cisco IOS IP Configuration Guide,
Release 12.2 from the Cisco.com page under Documentation > Cisco IOS Software > 12.2 Mainline
> Configuration Guides. For complete syntax and usage information for the commands used in this
chapter, see these command references from the Cisco.com page under Documentation > Cisco IOS
Software > 12.2 Mainline > Command References:
Release 12.2 from the Cisco.com page under Documentation > Cisco IOS Software > 12.2 Mainline
> Configuration Guides. For complete syntax and usage information for the commands used in this
chapter, see these command references from the Cisco.com page under Documentation > Cisco IOS
Software > 12.2 Mainline > Command References:
•
Cisco IOS IP Command Reference, Volume 1 of 3: Addressing and Services, Release 12.2
•
Cisco IOS IP Command Reference, Volume 2 of 3: Routing Protocols, Release 12.2
•
Cisco IOS IP Command Reference, Volume 3 of 3: Multicast, Release 12.2
This chapter consists of these sections:
•
•
•
•
•
•
•
•
•
•