Cisco Systems 3560 Manual De Usuario
36-12
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 36 Configuring IP Unicast Routing
Configuring IP Addressing
The only required task for IRDP routing on an interface is to enable IRDP processing on that interface.
When enabled, the default parameters apply. You can optionally change any of these parameters.
When enabled, the default parameters apply. You can optionally change any of these parameters.
Beginning in privileged EXEC mode, follow these steps to enable and configure IRDP on an interface:
If you change the maxadvertinterval value, the holdtime and minadvertinterval values also change,
so it is important to first change the maxadvertinterval value, before manually changing either the
holdtime or minadvertinterval values.
so it is important to first change the maxadvertinterval value, before manually changing either the
holdtime or minadvertinterval values.
Use the no ip irdp interface configuration command to disable IRDP routing.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Enter interface configuration mode, and specify the Layer 3 interface to
configure.
configure.
Step 3
ip irdp
Enable IRDP processing on the interface.
Step 4
ip irdp multicast
(Optional) Send IRDP advertisements to the multicast address
(224.0.0.1) instead of IP broadcasts.
(224.0.0.1) instead of IP broadcasts.
Note
This command allows for compatibility with Sun Microsystems
Solaris, which requires IRDP packets to be sent out as multicasts.
Many implementations cannot receive these multicasts; ensure
end-host ability before using this command.
Solaris, which requires IRDP packets to be sent out as multicasts.
Many implementations cannot receive these multicasts; ensure
end-host ability before using this command.
Step 5
ip irdp holdtime seconds
(Optional) Set the IRDP period for which advertisements are valid. The
default is three times the maxadvertinterval value. It must be greater
than maxadvertinterval and cannot be greater than 9000 seconds. If you
change the maxadvertinterval value, this value also changes.
default is three times the maxadvertinterval value. It must be greater
than maxadvertinterval and cannot be greater than 9000 seconds. If you
change the maxadvertinterval value, this value also changes.
Step 6
ip irdp maxadvertinterval seconds
(Optional) Set the IRDP maximum interval between advertisements. The
default is 600 seconds.
default is 600 seconds.
Step 7
ip irdp minadvertinterval seconds
(Optional) Set the IRDP minimum interval between advertisements. The
default is 0.75 times the maxadvertinterval. If you change the
maxadvertinterval, this value changes to the new default (0.75 of
maxadvertinterval).
default is 0.75 times the maxadvertinterval. If you change the
maxadvertinterval, this value changes to the new default (0.75 of
maxadvertinterval).
Step 8
ip irdp preference number
(Optional) Set a device IRDP preference level. The allowed range is –2
31
to 2
31
. The default is 0. A higher value increases the router preference
level.
Step 9
ip irdp address address [number]
(Optional) Specify an IRDP address and preference to proxy-advertise.
Step 10
end
Return to privileged EXEC mode.
Step 11
show ip irdp
Verify settings by displaying IRDP values.
Step 12
copy running-config startup-config
(Optional) Save your entries in the configuration file.