Cisco Systems Cisco ME 3400 Manual De Usuario
2-15
Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide
OL-7677-04
Chapter 2 Switch Installation
Installing the Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached securely to wall studs or
to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up, as
shown in
to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up, as
shown in
Warning
Suitable for mounting on and over a concrete or other non-combustible surface only. Statement 345
Figure 2-11
Mounting the Switch on a Wall
After the switch is mounted on the wall, you need to do these tasks to complete the installation:
•
Power on the switch. See the
•
Connect to a 10/100 port or to the RJ-45 connector of a dual-purpose port, and run the Initial
Configuration Dialog. See the Cisco ME 3400 and ME 2400 Ethernet Access Switches Getting
Started Guide for instructions.
Configuration Dialog. See the Cisco ME 3400 and ME 2400 Ethernet Access Switches Getting
Started Guide for instructions.
•
Connect to the front-panel ports. See the
and the
to complete the
installation.
For configuration instructions about using the CLI setup program, go to
1
User-supplied screws
132673
Cat
aly
st
37
50
SE
RIE
S
13X
14
X
SY
ST
2X
2X
1
1