Cisco Systems ME 2400 Manual De Usuario
D-5
Cisco ME 2400 Ethernet Access Switch Hardware Installation Guide
OL-7678-01
Appendix D Configuring the Switch with the CLI-Based Setup Program
Connecting to a Power Source
Connecting to a Power Source
Follow these steps to connect to an AC power source:
Step 1
Connect one end of the supplied AC power cord to the power connector on a switch rear panel. See
Step 2
Connect the other end of the power cable to a grounded AC outlet.
Follow these steps to connect to an DC power source. For detailed instructions for connecting to
DC power, see
DC power, see
Step 1
Connect one end of the supplied DC power cord to the power connector on a switch rear panel. See
Step 2
Connect the other end of the power cable to a grounded DC outlet.
When the switch powers on, it automatically begins the power-on self test (POST), a series of tests that
verifies that the switch functions properly. When the switch begins POST, the system LED slowly blinks
green. When POST completes, the system LED blinks amber. If POST fails, the system LED remains
amber. If POST completes successfully, the system LED rapidly blinks green.
verifies that the switch functions properly. When the switch begins POST, the system LED slowly blinks
green. When POST completes, the system LED blinks amber. If POST fails, the system LED remains
amber. If POST completes successfully, the system LED rapidly blinks green.
Note
POST failures are usually fatal. Call Cisco Systems if your switch does not pass POST.
If you started the terminal emulation program before you powered on your switch, the PC or terminal
displays the bootloader sequence. You need to press Enter to display the setup program prompt.
displays the bootloader sequence. You need to press Enter to display the setup program prompt.
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch
is powered up. You must assign an IP address and other configuration information necessary for the
switch to communicate with the local routers and the Internet.
is powered up. You must assign an IP address and other configuration information necessary for the
switch to communicate with the local routers and the Internet.
IP Settings
You will need this information from your network administrator before you complete the setup program:
•
Switch IP address
•
Subnet mask (IP netmask)
•
Default gateway (router)
•
Enable secret password
•
Enable password
•
Telnet password