Cisco Systems ME3600X24CXM Manual De Usuario

2-17

Cisco ME 3800X and ME 3600X Switch Hardware Installation Guide

OL-22168-01

Chapter 2 Switch Installation

Inserting and Removing the SFP+ Module Patch Cable

Figure 2-12

Removing a Bale-Clasp Latch SFP+ Module

Step 5

Grasp the SFP+ or SFP module, and carefully remove it from the module slot.

Step 6

For fiber-optic SFP+ or SFP modules, insert a dust plug into the optical ports of the SFP+ or SFP module
to keep the optical interfaces clean.

Step 7

Place the removed SFP+ or SFP module in an antistatic bag or other protective environment.

Inserting and Removing the SFP+ Module Patch Cable

Note

This section shows how to install and remove an SFP+ module patch cable into an SFP+ (uplink) module
slot. The procedure is the same for installing an SFP module patch cable into an SFP (downlink) module
slot.

To insert an SFP+ module patch cable into the SFP+ module slot, follow these steps:

Step 1

Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.

Step 2

Insert the SFP+ module patch cable into the slot until you feel the connector on the cable snap into place
in the rear of the slot (see

Figure 2-13

Bale clasp

207470