Cisco Systems ME3600X24CXM Manual De Usuario

Class 1 laser product. Statement 1008

Do not remove the rubber plugs from the SFP+ or SFP module port or the rubber caps from the 
fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP+ or SFP 
module ports and cables from contamination and ambient light.

Before connecting to the SFP+ or SFP module, be sure that you understand the port and cabling 
stipulations in the 

 and in the 

 for information about the 

LC on the SFP+ or SFP module.

Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use. 

Insert one end of the fiber-optic cable into the SFP+ or SFP module port (see 

).

Insert the other cable end into a fiber-optic connector on a target device.

Observe the port status LED.

The LED turns green when the switch and the target device have an established link.

The LED turns amber while the STP discovers the network topology and searches for loops. This process 
takes about 30 seconds, and then the port LED turns green.

If the LED is off, the target device might not be turned on, there might be a cable problem, or there might 
be problem with the adapter installed in the target device. See 

 for 

solutions to cabling problems.

If necessary, reconfigure and restart the switch or target device.

You can use the default configuration or use any of the management options described in the 

 to change the switch settings. 

207471

1

2