Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Cisco Systems
  4. 3560X
  5. Manual De Usuario

Cisco Systems 3560X Manual De Usuario

Descargar
Página de 1438
 
42-21
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 42      Configuring IP Unicast Routing
Configuring RIP
Default RIP Configuration
Configuring Basic RIP Parameters
Note
To configure RIP, you enable RIP routing for a network and optionally configure other parameters. On 
the Catalyst 3750-X and 3560-X switches, RIP configuration commands are ignored until you configure 
the network number. 
Beginning in privileged EXEC mode, follow these steps to enable and configure RIP:
Table 42-4
Default RIP Configuration 
Feature
Default Setting
Auto summary
Enabled.
Default-information originate
Disabled.
Default metric
Built-in; automatic metric translations.
IP RIP authentication key-chain No authentication.
Authentication mode: clear text.
IP RIP receive version
According to the version router configuration command.
IP RIP send version
According to the version router configuration command.
IP RIP triggered
According to the version router configuration command.
IP split horizon
Varies with media.
Neighbor
None defined.
Network
None specified.
Offset list
Disabled.
Output delay
0 milliseconds.
Timers basic
  •
Update: 30 seconds.
  •
Invalid: 180 seconds.
  •
Hold-down: 180 seconds.
  •
Flush: 240 seconds.
Validate-update-source
Enabled.
Version
Receives RIP Version 1 and 2 packets; sends Version 1 packets.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ip routing
 
Enable IP routing. (Required only if IP routing is disabled.)
Step 3
router rip
Enable a RIP routing process, and enter router configuration mode.