Cisco Systems 3560X Manual De Usuario
C-7
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Appendix C Unsupported Commands in Cisco IOS Release 12.2(53)SE2
IP Multicast Routing
IP Multicast Routing
Unsupported Privileged EXEC Commands
clear ip rtp header-compression
[type number]
The debug ip packet command displays packets received by the switch CPU. It does not display packets
that are hardware-switched.
that are hardware-switched.
The debug ip mcache command affects packets received by the switch CPU. It does not display packets
that are hardware-switched.
that are hardware-switched.
The debug ip mpacket [detail] [access-list-number [group-name-or-address] command affects only
packets received by the switch CPU. Because most multicast packets are hardware-switched, use this
command only when you know that the route will forward the packet to the CPU.
packets received by the switch CPU. Because most multicast packets are hardware-switched, use this
command only when you know that the route will forward the packet to the CPU.
debug ip pim atm
show frame-relay ip rtp header-compression
[interface type number]
The show ip mcache command displays entries in the cache for those packets that are sent to the switch
CPU. Because most multicast packets are switched in hardware without CPU involvement, you can use
this command, but multicast packet information is not displayed.
CPU. Because most multicast packets are switched in hardware without CPU involvement, you can use
this command, but multicast packet information is not displayed.
The show ip mpacket commands are supported but are only useful for packets received at the switch
CPU. If the route is hardware-switched, the command has no effect because the CPU does not receive
the packet and cannot display it.
CPU. If the route is hardware-switched, the command has no effect because the CPU does not receive
the packet and cannot display it.
show ip pim vc
[group-address | name] [type number]
show ip rtp header-compression
[type number] [detail]
Unsupported Global Configuration Commands
ip multicast-routing vrf vrf-name
ip pim accept-rp
{address | auto-rp} [group-access-list-number]
ip pim message-interval
seconds
Unsupported Interface Configuration Commands
frame-relay ip rtp header-compression
[active | passive]
frame-relay map ip
ip-address dlci [broadcast] compress
frame-relay map ip
ip-address dlci rtp header-compression [active | passive]
ip igmp helper-address
ip-address
ip multicast helper-map
{group-address | broadcast} {broadcast-address | multicast-address}
extended-access-list-number
ip multicast rate-limit
{in | out} [video | whiteboard] [group-list access-list] [source-list access-list]
kbps
ip multicast ttl-threshold
ttl-value (instead, use the ip multicast boundary access-list-number
interface configuration command)