Cisco Systems 3560X Manual De Usuario
13-45
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 13 Configuring Interface Characteristics
Monitoring and Maintaining the Interfaces
Monitoring and Maintaining the Interfaces
These sections contain interface monitoring and maintenance information:
•
•
•
Monitoring Interface Status
Commands entered at the privileged EXEC prompt display information about the interface, including
the versions of the software and the hardware, the configuration, and statistics about the interfaces.
the versions of the software and the hardware, the configuration, and statistics about the interfaces.
commands by using the show ? command at the privileged EXEC prompt.) These commands are fully
described in the Cisco IOS Interface Command Reference, Release 12.2.
described in the Cisco IOS Interface Command Reference, Release 12.2.
Table 13-6
Show Commands for Interfaces
Command
Purpose
show env power switch
[switch-number]
(Optional) Display the status of the internal power supplies for each
switch in the stack or for the specified switch. The range is 1 to 9,
depending on the switch member numbers in the stack.
switch in the stack or for the specified switch. The range is 1 to 9,
depending on the switch member numbers in the stack.
These keywords are available only on Catalyst 3750-E switches.
show env rps
Display whether a redundant power system (RPS) is connected to the
switch as follows:
switch as follows:
–
Catalyst 3750-E or 3560-E switch—Cisco Redundant Power
System 2300, also referred to as the RPS 2300.
System 2300, also referred to as the RPS 2300.
–
Catalyst 3750v2 or 3560v2 switch—Cisco Redundant Power
System 2300.
System 2300.
–
Catalyst 3750, 3560, 2970, or 2960 switches—RPS 2300 or
Cisco RPS 675 Redundant Power System, also referred to as
the RPS 675.
Cisco RPS 675 Redundant Power System, also referred to as
the RPS 675.
show env
rps detail
(Optional) Display the details about the RPSs that are connected to the
switch or switch stack.
switch or switch stack.
show env rps switch
[switch-number]
(Optional) Display the RPSs that are connected to each switch in the
stack or to the specified switch. The range is 1 to 9, depending on the
switch member numbers in the stack.
stack or to the specified switch. The range is 1 to 9, depending on the
switch member numbers in the stack.
show interfaces
[interface-id]
Display the status and configuration of all interfaces or a specific
interface.
interface.
show interfaces
interface-id status [err-disabled]
Display interface status or a list of interfaces in the error-disabled
state.
state.
show interfaces
[interface-id] switchport
Display administrative and operational status of switching
(nonrouting) ports. You can use this command to find out if a port is in
routing or in switching mode.
(nonrouting) ports. You can use this command to find out if a port is in
routing or in switching mode.