Cisco Systems 3560X Manual De Usuario
14-11
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 14 Configuring Auto Smartports Macros
Configuring Auto Smartports
Current configuration : 284 bytes
!
interface GigabitEthernet1/0/1
interface GigabitEthernet0/1
switchport trunk encapsulation dot1q
switchport trunk native vlan 10
switchport mode trunk
srr-queue bandwidth share 10 10 60 20
queue-set 2
priority-queue out
mls qos trust cos
auto qos voip trust
macro description CISCO_SWITCH_EVENT
end
This example shows how to configure the remote macro with the setting for native VLAN 5.
a.
Configure the remote macro in the macro.txt file.
b.
Use the macro auto execute configuration command to specify the remote location for the macro
file.
file.
if [[ $LINKUP -eq YES ]]; then
conf t
interface $INTERFACE
macro description $TRIGGER
auto qos voip trust
switchport trunk encapsulation dot1q
switchport trunk native vlan $NATIVE_VLAN
switchport trunk allowed vlan ALL
switchport mode trunk
exit
end
else
conf t
interface $INTERFACE
no macro description
no auto qos voip trust
no switchport mode trunk
no switchport trunk encapsulation dot1q
no switchport trunk native vlan $NATIVE_VLAN
no switchport trunk allowed vlan ALL
exit
end
Switch(config)# macro auto execute CISCO_SWITCH_EVENT remote tftp://<ip_address>/macro.txt
NATIVE_VLAN=5
Switch# show running configuration | include macro
macro auto execute CISCO_SWITCH_EVENT remote tftp://<ip_address>/macro.txt
NATIVE_VLAN=5
Switch#
Creating User-Defined Event Triggers
When using MAB or 802.1x authentication to trigger Auto Smartports macros, you need to create an
event trigger that corresponds to the Cisco attribute-value pair (auto-smart-port=event trigger) sent by
the RADIUS server. This procedure is optional.
event trigger that corresponds to the Cisco attribute-value pair (auto-smart-port=event trigger) sent by
the RADIUS server. This procedure is optional.