Cisco Systems 3560X Manual De Usuario
40-18
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 40 Configuring EtherChannels and Link-State Tracking
Configuring EtherChannels
This example shows how to configure an EtherChannel. It assigns two ports to channel 5 with the LACP
mode active:
mode active:
Switch# configure terminal
Switch(config)# interface range gigabitethernet2/0/1 -2
Switch(config-if-range)# no ip address
Switch(config-if-range)# no switchport
Switch(config-if-range)# channel-group 5 mode active
Switch(config-if-range)# end
This example shows how to configure a cross-stack EtherChannel. It assigns two ports on stack member
2 and one port on stack member 3 to channel 7 using LACP active mode:
2 and one port on stack member 3 to channel 7 using LACP active mode:
Switch# configure terminal
Switch(config)# interface range gigabitethernet2/0/4 -5
Switch(config-if-range)# no ip address
Switch(config-if-range)# no switchport
Switch(config-if-range)# channel-group 7 mode active
Switch(config-if-range)# exit
Switch(config)# interface gigabitethernet3/0/3
Switch(config-if)# no ip address
Switch(config-if)# no switchport
Switch(config-if)# channel-group 7 mode active
Switch(config-if)# exit
Configuring EtherChannel Load-Balancing
This section describes how to configure EtherChannel load-balancing by using source-based or
destination-based forwarding methods. For more information, see the
destination-based forwarding methods. For more information, see the
Beginning in privileged EXEC mode, follow these steps to configure EtherChannel load-balancing. This
procedure is optional.
procedure is optional.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
port-channel load-balance
{dst-ip | dst-mac |
src-dst-ip
| src-dst-mac | src-ip | src-mac}
Configure an EtherChannel load-balancing method.
The default is src-mac.
Select one of these load-distribution methods:
•
dst-ip
—Load distribution is based on the destination-host IP
address.
•
dst-mac
—Load distribution is based on the destination-host
MAC address of the incoming packet.
•
src-dst-ip
—Load distribution is based on the
source-and-destination host-IP address.
•
src-dst-mac
—Load distribution is based on the
source-and-destination host-MAC address.
•
src-ip
—Load distribution is based on the source-host IP
address.
•
src-mac
—Load distribution is based on the source-MAC
address of the incoming packet.