Cisco Systems Catalyst 3850 Manual De Usuario
Step 4
Position the module face up to install it in the module slot. Slide the module into the slot until the back of the
module faceplate is flush with the switch faceplate. Fasten the captive screws to secure the network module
in place.
module faceplate is flush with the switch faceplate. Fasten the captive screws to secure the network module
in place.
Figure 31: Installing the Network Module in the Switch
Network Module Port Configurations
All ports in this module are natively GigabitEthernet and are configured GigabitEthernet1/1/1 though
GigabitEthernet1/1/4. There are only four interfaces that are valid, and the other four should not be used even
though they still show up in the CLI.
GigabitEthernet1/1/4. There are only four interfaces that are valid, and the other four should not be used even
though they still show up in the CLI.
Table 20: C3850-NM-4-1G Module
Action
Interface
Configure this interface
GigabitEthernet1/1/1
Configure this interface
GigabitEthernet1/1/2
Configure this interface
GigabitEthernet1/1/3
Configure this interface
GigabitEthernet1/1/4
Disregard
TenGigabitEthernet1/1/1
Catalyst 3850 Switch Hardware Installation Guide
OL-26779-04
51
Installing a Network Module
Network Module Port Configurations