Cisco Systems Cisco ME 3400E Manual De Usuario
2-6
Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide
OL-16447-01
Chapter 2 Switch Installation
Installing the Switch
Rack-Mounting
To install the switch in a 19-inch, 23-inch, 24-inch rack, or a European Telecommunications Standards
Institute (ETSI) rack, follow these instructions. (The 24-inch racks and the ETSI racks require optional
mounting hardware.)
Institute (ETSI) rack, follow these instructions. (The 24-inch racks and the ETSI racks require optional
mounting hardware.)
•
•
•
.
Note
Installing the switch in a 24-inch rack requires an optional bracket kit that is not included with the
switch. You can order a kit containing the 24-inch rack-mounting brackets and hardware from Cisco.
The kit part number is RCKMNT-1RU= (700-12398-XX).
switch. You can order a kit containing the 24-inch rack-mounting brackets and hardware from Cisco.
The kit part number is RCKMNT-1RU= (700-12398-XX).
Removing Screws from the Switch
First remove the screws in the switch chassis so that the mounting brackets can be attached (
).
Figure 2-2
Removing Screws from the Switch
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
•
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
the rack.
the rack.
Statement 1006
280834