Cisco Systems Cisco 7507 Manual De Usuario
Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 5
Rack-Mount Kit Overview
In Telco-type installations, you can install the chassis so that the ends of the chassis are
approximately centered on two posts. Figure 3 shows a typical center-mount installation.
approximately centered on two posts. Figure 3 shows a typical center-mount installation.
Caution
To maintain a safe center of gravity in Telco-type installations (shown in Figure 3), the
front and rear of the chassis are approximately centered on the mounting posts.
Figure 3
Typical Center-Mount Installation
In a 2-post, 4-post, or Telco-type installation, you can flush-mount the chassis so that the end of the
chassis is flush with the rack posts. (When mounting the non-interface processor end, the front is
actually recessed 1 inch into the rack to protect the plastic front bezel.) Multiple-chassis rack kits
can be stacked in a rack with little or no clearance between the brackets. You can remove the four
chassis feet after mounting the chassis in the rack.
chassis is flush with the rack posts. (When mounting the non-interface processor end, the front is
actually recessed 1 inch into the rack to protect the plastic front bezel.) Multiple-chassis rack kits
can be stacked in a rack with little or no clearance between the brackets. You can remove the four
chassis feet after mounting the chassis in the rack.
H2296