Cisco Systems IE301016S8PC Manual De Usuario

After completing Express Setup and installing the switch in your network, you 
can use the CLI for further configuration. You can enter Cisco IOS commands and 
parameters through the CLI. Use one of these options to access the CLI:

Connect the RJ-45-to-DB-9 adapter cable to the 9-pin serial port on the PC. 
Connect the other end of the cable to the switch console port.

Start a terminal-emulation program on the PC.

Configure the PC terminal emulation software for 9600 baud, 8 data bits, no 
parity, 1 stop bit, and no flow control.

Use the CLI to enter configuration commands. See the software configuration 
guide and the command reference for more information.

If you use the USB console port, you must install the Cisco Windows USB device 
driver on the PC that is connected to the USB console port. See the switch 
hardware installation guide for installation instructions.

Connect an USB cable to the PC USB port. Connect the other end of the cable 
to the mini-B (5-pin-connector) USB console port on the switch.

Start a terminal-emulation program on the PC.

Disconnect the switch from the PC, and install the switch in your network. See the 

.

If you changed the static IP address on your PC in 

, change it to the previously 

configured static IP address.

 See the 

 for information about configuring and 

managing the switch.