Cisco Systems Catalyst 2955 Manual De Usuario
3-57
Catalyst 2955 Hardware Installation Guide
78-14944-03
Chapter 3 Installation
Installing the Switch in a Rack
Note
For instructions on how to remove the switch from a DIN rail, see the
Installing the Switch in a Rack
You can use an optional DIN rail adapter kit (available through Cisco, part number
STK-RACKMNT-2955=) to mount the Catalyst 2955 switch in a 19-inch rack.
The rack mounting kit comes with a DIN rail adapter and screws to attach the
adapter to the rack. Ask your Cisco representative for details.
STK-RACKMNT-2955=) to mount the Catalyst 2955 switch in a 19-inch rack.
The rack mounting kit comes with a DIN rail adapter and screws to attach the
adapter to the rack. Ask your Cisco representative for details.
Caution
To prevent the switch from overheating, there must be a minimum of 3 inches
between any other device and the top, bottom, or sides of the switch.
between any other device and the top, bottom, or sides of the switch.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
•
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•
When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
top with the heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack.
or servicing the unit in the rack.
Statement 1006