Cisco Systems Catalyst 2955 Manual De Usuario
3-67
Catalyst 2955 Hardware Installation Guide
78-14944-03
Chapter 3 Installation
Connecting to 100BASE-LX SM Ports
Connecting to 100BASE-LX SM Ports
Warning
Invisible laser radiation may be emitted from disconnected fibers or
connectors. Do not stare into beams or view directly with optical instruments.
Statement 1051
connectors. Do not stare into beams or view directly with optical instruments.
Statement 1051
Warning
Avoid direct exposure to the laser beam. Statement 1012
You can connect a 100BASE-LX port to a port on a target device by using one of
the LC fiber-optic patch cables listed in
the LC fiber-optic patch cables listed in
. Use the Cisco part
numbers in
to order the patch cables that you need.
Follow these steps to connect the switch to a 100BASE-LX SM device:
Caution
Do not remove the dust plugs from the fiber-optic ports or the rubber caps from
the fiber-optic cable until you are ready to connect the cable. The plugs and caps
protect the fiber-optic ports and cables from contamination and ambient light.
the fiber-optic cable until you are ready to connect the cable. The plugs and caps
protect the fiber-optic ports and cables from contamination and ambient light.
Step 1
Remove the dust plugs from the 100BASE-LX port, as shown in
, and
store them for future use. Remove the rubber caps from the LC on the fiber-optic
cable. Store them for future use.
cable. Store them for future use.
Figure 3-38
Removing Dust Plugs from 100BASE-LX Ports
87054
13
14
100Base-LX