Cisco Systems IGX 8400 Series Manual De Usuario
Card Installation and Node Startup 3-7
Inserting the Cards
Inserting the Cards
To insert a Cisco IGX module:
Step 1
Attach an ESD-preventive wrist strap to handle the cards.
Note
The IGX 8410 cabinet has an attached wrist strap both at the front and back.
Step 2
Using the 5/32-inch Allen wrench, open the Cisco IGX 8400 Series switch door.
Step 3
Be sure that you are inserting the module into the correct slot.
Step 4
Grasp the card front panel with one hand and place your other hand under the card to
balance the weight of the card as you push it vertically into the slot. (See Figure 3-6.)
balance the weight of the card as you push it vertically into the slot. (See Figure 3-6.)
Figure 3-6
Inserting Modules
Step 5
Push down on the ejector levers to properly seat the card.
Caution
Always use the ejector levers when disengaging or seating the modules. Failure to do so can cause
erroneous system error messages, and indicate card failure. However, do not use the ejector levers to lift or
support the weight of the cards.
support the weight of the cards.
Step 6
Using the number 1 Phillips screwdriver, tighten the panel fasteners at the top and bottom
of the card front panel.
of the card front panel.
RMON
TMON
PWR
E1FR
HCPU
MAINT
T1FR
FCPU
CHANNELIZED E1/T1
RALM
LALM
0
MONIT
OR#
NLOOP
75
1
2
3
4
5
6
7
8
9
10
11
29866
SYSTEM
STATUS
NPM
ALM
LDM
UXM
HDM
UFM
NTM
ACTIVE
FAIL
RL
DTR
TXD
DCD
RXD
LL
RL
DTR
TXD
DCD
RXD
LL
MAJOR
MINOR
MAJOR
MINOR
MAJOR
MINOR
ACTIVE
STANDBY
FAIL
ACTIVE
FAIL
ACTIVE
FAIL