Cisco Systems EA6500 Manual De Usuario

Descargar
Página de 570
 
17-6
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
78-14099-04
Chapter 17      Configuring IP Unicast Layer 3 Switching on Supervisor Engine 2
Displaying Hardware Layer 3 Switching Statistics
Displaying Hardware Layer 3 Switching Statistics
Hardware Layer 3 switching statistics are obtained on a per-VLAN basis.
To display hardware Layer 3 switching statistics, perform this task:
This example shows how to display hardware Layer 3 switching statistics:
Router# show interfaces gigabitethernet 9/5 | include Switched 
L2 Switched: ucast: 8199 pkt, 1362060 bytes - mcast: 6980 pkt, 371952 bytes
L3 in Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes mcast
L3 out Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes 
To display adjacency table information, perform this task:
This example shows how to display adjacency statistics:
Router# show adjacency gigabitethernet 9/5 detail 
Protocol Interface                 Address
IP       GigabitEthernet9/5        172.20.53.206(11)
                                   504 packets, 6110 bytes
                                   00605C865B82
                                   000164F83FA50800
                                   ARP        03:49:31 
Note
Adjacency statistics are updated approximately every 60 seconds.
Command
Purpose
Router# show interfaces {{type
1
 slot/port} | 
{port-channel number}} 
1.
type = ethernetfastethernetgigabitethernet, or tengigabitethernet 
Displays hardware Layer 3 switching statistics.
Command
Purpose
Router# show adjacency [{{type
1
 slot/port} | 
{port-channel number}} | detail | internal | summary]
1.
type = ethernetfastethernetgigabitethernet, or tengigabitethernet 
Displays adjacency table information. The optional detail 
keyword displays detailed adjacency information, including 
Layer 2 information.