Cisco Systems EA6500 Manual De Usuario

This example shows how to enable NetFlow-based rate limiting of non-RPF failures globally:

Router(config)# mls ip multicast non-rpf netflow 

Router(config)#

CEF-based rate limiting of RPF failures is enabled by default on systems with PFC2. CEF-based rate 
limiting of RPF failures can be configured globally only. 

To enable CEF-based rate limiting of RPF failures, perform this task:

This example shows how to enable CEF-based rate limiting of RPF failures globally:

Router(config)# mls ip multicast non-rpf CEF

Router(config)#

When you enable the shortcut-consistency checking feature, the multicast route table and the 
multicast-hardware entries are are checked for consistency, and any inconsistencies are corrected. You 
can view inconsistencies by entering the show mls ip multicast consistency-check command. 

If consistency checking is enabled, the multicast route table will be scanned every two seconds and a full 
scan is completed within 4 mintues. 

To enable shortcut-consistency checking, perform this task:

Router(config-if)# mls ip multicast non-rpf 

 

Enables NetFlow-based rate limiting of RPF failures on 
the Layer 3 interface.

Router(config-if)# no mls ip multicast non-rpf 

 

Disables NetFlow-based rate limiting of RPF failures on 
the Layer 3 interface.

1.

type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet 

Router(config)# mls ip multicast non-rpf cef 

Enables CEF-based rate limiting of RPF failures globally.

Router(config)# no mls ip multicast non-rpf cef 

Disables CEF-based rate limiting of RPF failures globally.

Router(config)# mls ip multicast consistency-check 

Enables shortcut-consistency checking.

Router(config)# no mls ip multicast consistency-check 

num 

Restores the default.