Cisco Systems EA6500 Manual De Usuario

IP MLS is permanently enabled globally but can be disabled and enabled on a specified interface.

To enable IP MLS on a specific interface, perform this task:

This example shows how to disable IP MLS for Fast Ethernet port 5/5:

Router(config)# interface fastethernet 5/5

Router(config-if)# no mls ip

Router(config-if)#

IP MLS is enabled by default; you only need to enable it if you have previously disabled it.

To display the IP MLS configuration on a Layer 3 interface, perform this task:

This example shows how to display the IP MLS configuration for Fast Ethernet port 5/4:

Router# show ip interface fastethernet 5/4 

FastEthernet5/4 is up, line protocol is up

  Internet address is 172.20.52.106/29

  Broadcast address is 255.255.255.255

  Address determined by non-volatile memory

  MTU is 1500 bytes

  Helper address is not set

  Directed broadcast forwarding is disabled

  Multicast reserved groups joined: 224.0.0.10

  Outgoing access list is not set

  Inbound  access list is not set

  Proxy ARP is enabled

  Security level is default

  Split horizon is enabled

  ICMP redirects are always sent

  ICMP unreachables are always sent

  ICMP mask replies are never sent

  IP fast switching is enabled

  IP fast switching on the same interface is disabled

Router(config)# interface {{vlan vlan_ID} | 

{type

1

 slot/port} | {port-channel number}}

1.

type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet 

Selects an interface to configure.

Router(config-if)# mls ip 

Enables IP MLS on an interface. 

Router(config-if)# no mls ip 

Disables IP MLS on an interface. 

Router# show ip {interface {{vlan vlan_ID} | 

{type

1

 slot/port} | {port-channel number}} | 

} 

1.

type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet 

Displays IP MLS configuration for an interface.