Cisco Systems EA6500 Manual De Usuario

To configure an action clause in a VLAN access map sequence, perform this task:

When configuring an action clause in a VLAN access map sequence, note the following syntax 
information:

You can set the action to drop, forward, forward capture, or redirect packets.

VACLs applied to WAN interfaces support only the forward capture action. VACLs applied to WAN 
interfaces do not support the drop, forward, or redirect actions.

Forwarded packets are still subject to any configured Cisco IOS security ACLs.

The capture action sets the capture bit for the forwarded packets so that ports with the capture 
function enabled can receive the packets. Only forwarded packets can be captured. For more 
information about the capture action, see the 

.

The log action is supported only on Supervisor Engine 2.

VACLs applied to WAN interfaces do not support the log action.

When the log action is specified, dropped packets are logged in software. Only dropped IP packets 
can be logged. 

The redirect action allows you to specify up to five interfaces, which can be physical interfaces or 
EtherChannels. You cannot specify packets to be redirected to an EtherChannel member or a VLAN 
interface.

For systems with a Supervisor Engine 2, the redirect interface must be in the VLAN for which the 
VACL access map is configured. For systems with Supervisor Engine 1, the redirect interface must 
be in the redirected packet’s source VLAN.

Use the no keyword to remove an action clause or specified redirect interfaces.

See the 

To apply a VLAN access map, perform this task:

Router(config-access-map)# action {drop [log]} | 

{forward [capture]} | {redirect {{ethernet | 

 | gigabitethernet | tengigabitethernet} 

slot/port} | {port-channel channel_id}}

Configures the action clause in a VLAN access map 
sequence.

Router(config-access-map)# no action {drop [log]} | 

{forward [capture]} | {redirect {{ethernet | 

 | gigabitethernet | tengigabitethernet} 

slot/port} | {port-channel channel_id}}

Deletes the action clause in from the VLAN access map 
sequence.

Router(config)# vlan filter map_name {vlan-list 

vlan_list | interface type

1

 number

2

} CP_CmdPlain

Applies the VLAN access map to the specified VLANs or 
WAN interfaces.