Cisco Systems EA6500 Manual De Usuario

To configure the policy map class trust state, perform this task: 

When configuring the policy map class trust state, note the following:

Enter the no trust command to use the trust state configured on the ingress port (this is the default).

With the cos keyword, PFC QoS sets the internal DSCP value from received or ingress port CoS (see 
the 

).

With the dscp keyword, PFC QoS uses received DSCP.

With the ip-precedence keyword, PFC QoS sets DSCP from received IP precedence (see the 

When you configure policy map class policing, note the following:

PFC QoS does not support the set-qos-transmit policer keyword.

PFC QoS does not support the set-dscp-transmit or set-prec-transmit keywords as arguments to 
the exceed-action keyword. 

PFC QoS does not detect the use of unsupported keywords until you attach a policy map to an 
interface (see the 

These sections describe configuration of policy map class policing:

Policing with the conform-action transmit keywords sets the port trust state of matched traffic to trust 
DSCP or to the trust state configured by a trust command in the policy map class. 

To use a named aggregate policer (see the 

perform this task: 

Router(config-pmap-c)# trust {cos | dscp | 

} 

Configures the policy map class trust state, which selects the 
value that PFC QoS uses as the source of the internal DSCP 
value (see the 

).

Router(config-pmap-c)# no trust 

Reverts to the default policy-map class trust state (untrusted).

Router(config-pmap-c)# police aggregate 

aggregate_name 

Configures the policy map class to use a previously defined 
named aggregate policer. 

Router(config-pmap-c)# no police aggregate 

aggregate_name 

Clears use of the named aggregate policer.