Cisco Systems EA6500 Manual De Usuario

To configure the mapping of received IP precedence values to the DSCP value that PFC QoS uses 
internally on the PFC (see the 

), perform this task: 

This example shows how to configure the received IP precedence to internal DSCP map:

Router# configure terminal 

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)# mls qos map ip-prec-dscp 0 1 2 3 4 5 6 7 

Router(config)# end 

Router# 

This example shows how to verify the configuration:

Router# show mls qos maps | begin IpPrecedence-dscp map 

   IpPrecedence-dscp map:

     ipprec:   0  1  2  3  4  5  6  7 

     ----------------------------------

       dscp:   0  1  2  3  4  5  6  7

<...Output Truncated...>

Router#

To configure the mapping of the DSCP value that PFC QoS uses internally on the PFC to the CoS value 
used for egress LAN port scheduling and congestion avoidance (see the 

 and the 

), perform this task: 

When configuring the internal DSCP to egress CoS map, note the following:

You can enter up to 8 DSCP values that PFC QoS maps to a CoS value.

You can enter multiple commands to map additional DSCP values to a CoS value.

You can enter a separate command for each CoS value.

Router(config)# mls qos map ip-prec-dscp dscp1 

dscp2 dscp3 dscp4 dscp5 dscp6 dscp7 dscp8 

Configures the received IP precedence to internal DSCP 
map. You must enter 8 internal DSCP values to which 
PFC QoS maps received IP precedence values 0 
through 7.

Router(config)# no mls qos map ip-prec-dscp 

Reverts to the default map. 

Router(config)# end 

Exits configuration mode.

Router# show mls qos maps 

Verifies the configuration.

Router(config)# mls qos map dscp-cos dscp1 [dscp2 

[dscp3 [dscp4 [dscp5 [dscp6 [dscp7 [dscp8]]]]]]] 

 cos_value 

Configures the internal DSCP to egress CoS map. 

Router(config)# no mls qos map dscp-cos 

Reverts to the default map. 

Router(config)# end 

Exits configuration mode.

Router# show mls qos maps 

Verifies the configuration.