Cisco Systems EA6500 Manual De Usuario

For detailed interface configuration information, refer to the Cisco IOS Interface Configuration Guide 
at this URL:

If you prefer not to use the setup facility, you can configure the switch from configuration mode as 
follows:

Connect a console terminal to the console interface of your supervisor engine. 

When you are asked if you want to enter the initial dialog, answer no to enter the normal operating mode 
as follows:

Would you like to enter the initial dialog? [yes]: no

After a few seconds you will see the user EXEC prompt (

Router>

). Type enable to enter enable mode: 

Router> enable

Configuration changes can only be made in enable mode.

The prompt will change to the privileged EXEC prompt (#) as follows:

Router#

At the prompt (#), enter the configure terminal command to enter configuration mode as follows:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#

At the prompt, enter the interface type slot/interface command to enter interface configuration mode as 
follows:

Router(config)# interface fastethernet 5/1

Router(config-if)# 

In either of these configuration modes, you can enter any changes to the configuration. Enter the end 
command to exit configuration mode. 

Save your settings. (See the 

.)

Your switch is now minimally configured and can boot with the configuration you entered. To see a list 
of the configuration commands, enter ? at the prompt or press the help key in configuration mode. 

You can check the configuration settings you entered or changes you made by entering the show 
running-config command at the privileged EXEC prompt (#) as follows:

Router# show running-config

Building configuration...