Cisco Systems EA6500 Manual De Usuario
32-4
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
78-14099-04
Chapter 32 Configuring UDLD
Configuring UDLD
Enabling UDLD on Individual LAN Interfaces
With Release 12.1(13)E and later releases, to enable UDLD on individual LAN ports, perform this task:
With earlier releases, to enable UDLD on individual LAN ports, perform this task:
Command
Purpose
Step 1
Router(config)# interface type
1
slot/port
1.
type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Selects the LAN port to configure.
Step 2
Router(config-if)# udld port [aggressive]
Enables UDLD on a specific LAN port. Enter the
aggressive keyword to enable aggressive mode. On a
fiber-optic LAN port, this command overrides the udld
enable global configuration command setting.
aggressive keyword to enable aggressive mode. On a
fiber-optic LAN port, this command overrides the udld
enable global configuration command setting.
Router(config-if)# no udld port [aggressive]
Disables UDLD on a nonfiber-optic LAN port.
Note
On fiber-optic LAN ports, the no udld port
command reverts the LAN port configuration to
the udld enable global configuration command
setting.
command reverts the LAN port configuration to
the udld enable global configuration command
setting.
Step 3
Router# show udld type
slot/number
Verifies the configuration.
Command
Purpose
Step 1
Router(config)# interface type
1
slot/port
1.
type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
Selects the LAN port to configure.
Step 2
Router(config-if)# udld enable [aggressive]
Enables UDLD on a specific LAN port. Enter the
aggressive keyword to enable aggressive mode. On a
fiber-optic LAN port, this command overrides the udld
enable global configuration command setting.
aggressive keyword to enable aggressive mode. On a
fiber-optic LAN port, this command overrides the udld
enable global configuration command setting.
Router(config-if)# no udld enable [aggressive]
Disables UDLD on a nonfiber-optic LAN port.
Note
On fiber-optic LAN ports, the no udld enable
command reverts the LAN port configuration to
the udld enable global configuration command
setting.
command reverts the LAN port configuration to
the udld enable global configuration command
setting.
Step 3
Router# show udld type
slot/number
Verifies the configuration.