Cisco Systems EA6500 Manual De Usuario

To configure an MD5 password for use by the router in WCCP communications, perform this task in 
global configuration mode:

To verify and monitor the configuration settings for WCCP, use the following commands in EXEC mode:

This section provides the following configuration examples:

Router(config)# ip wccp web-cache password password 

Sets an MD5 password on the router.

Router# show ip wccp [web-cache | service-number]

Displays global information related to WCCP, including 
the protocol version currently running, the number of 
cache engines in the routers service group, which cache 
engine group is allowed to connect to the router, and 
which access list is being used.

Router# show ip wccp {web-cache | service-number} detail 

Queries the router for information on which cache 
engines of a specific service group the router has 
detected. The information can be displayed for either 
the web cache service or the specified dynamic service.

Router# show ip interface 

Displays status about whether any ip wccp redirection 
commands are configured on an interface. For example, 
“Web Cache Redirect is enabled / disabled.”

Router# show ip wccp {web-cache | service-number} view 

Displays which devices in a particular service group 
have been detected and which cache engines are having 
trouble becoming visible to all other routers to which 
the current router is connected. The view keyword 
indicates a list of addresses of the service group. The 
information can be displayed for either the web cache 
service or the specified dynamic service. For further 
troubleshooting information, use the show ip wccp 
{web-cache | service number} service command.