Cisco Systems EA6500 Manual De Usuario

The interface-range configuration mode allows you to configure multiple interfaces with the same 
configuration parameters. After you enter the interface-range configuration mode, all command 
parameters you enter are attributed to all interfaces within that range until you exit out of the 
interface-range configuration mode.

To configure a range of interfaces with the same configuration, perform this task:

When configuring a range of interfaces, note the following syntax information:

For information about macros, see the 

You can enter up to five comma-separated ranges.

You are not required to enter spaces before or after the comma.

With releases earlier than Release 12.1(26)E, you must add a space between the interface numbers 
and the dash when using the interface range command. For example, interface range fastethernet 
1 - 5 is valid syntax; interface range fastethernet 1-5 is invalid.

With Release 12.1(26)E and later releases, you do not need to add a space between the interface 
numbers and the dash when using the interface range command.

With releases earlier than Release 12.1(14)E, the interface range command supports these interface 
keywords:

ethernet 

fastethernet 

gigabitethernet 

tengigabitethernet 

With Release 12.1(14)E and later releases, the interface range command supports these additional 
interface keywords:

pos 

loopback 

tunnel 

With Release 12.1(14)E and later releases, you can use the no interface range command to delete 
VLAN interfaces.

With releases earlier than Release 12.1(14)E, you cannot use the no keyword with the range 
keyword to delete VLAN interfaces.

With Release 12.1(14)E and later releases, you can use the interface range command to create 
VLAN interfaces.

Router(config)# interface range 

{{vlan vlan_ID - vlan_ID [, vlan vlan_ID - vlan_ID]} 

| {type slot/port - port [, type slot/port - port]} | 

{macro_name [, macro_name]}} 

Selects the range of interfaces to be configured.

Router(config)# no interface range 

{{vlan vlan_ID - vlan_ID [, vlan vlan_ID - vlan_ID]} 

| {macro_name [, macro_name]}} 

Selects the range of VLAN interfaces to remove.