Cisco Systems IE301024TC Manual De Usuario
2-21
Cisco IE 3010 Switch Hardware Installation Guide
78-19581-02
Chapter 2 Switch Installation
Inserting and Removing the SFP Module Patch Cable
Removing SFP Modules
Step 1
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 2
Disconnect the cable from the SFP module. For reattachment, note which cable connector plug is send
(TX) and which is receive (RX).
(TX) and which is receive (RX).
Step 3
Insert a dust plug into the optical ports of the SFP module.
Step 4
If the module has a bale-clasp latch, pull the bale out and down to eject it. If the latch is obstructed and
you cannot use your finger, use a small, flat-blade screwdriver or other long, narrow instrument.
you cannot use your finger, use a small, flat-blade screwdriver or other long, narrow instrument.
Step 5
Grasp the SFP module, and carefully remove it from the slot.
Step 6
Place the module in an antistatic bag or other protective environment.
Figure 2-17
Removing a Bale-Clasp Latch SFP Module
Inserting and Removing the SFP Module Patch Cable
Step 1
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 2
Insert the SFP module patch cable in the slot until you feel the connector on the cable snap into place at
the rear of the slot (see
the rear of the slot (see
).
1
Bale clasp
208371
1
C isco IE 3010