Cisco Systems IE 3010 Manual De Usuario

After the switch is mounted in the rack:

Wire the switch to a power source. See 

Connect the ports. See the 

.

We recommend attaching the cable guide to prevent the cables from obscuring the LED panels on 
the devices in the rack. Use the supplied black screw shown in 

 to attach the cable guide 

to the left or right bracket.

For configuration instructions about the CLI setup program, go to 

To wall-mount the switch, follow the steps in these sections:

Read the wall-mounting instructions carefully before beginning installation. Failure to use the 
correct hardware or to follow the correct procedures could result in a hazardous situation to people 
and damage to the system. Statement 378

For mounting railway-application equipment and for  EN50155 standard compliance, the switch must 
be installed only in a rack mid-mounting position.  If you install the switch in a front rack-mounting 
(cable side or power supply side) position or in a wall-mounting position,  a  mechanical failure can 
occur that results in the switch becoming detached from the rack. Statement 403

If the switch is wall-mounted in an enclosure, follow these minimum clearances:

 

- Sides of switch (facing up and facing down): 3.75 in. (9.52 cm)

 

- Port side 3.0 in. (7.62 cm)

 

- Power supply side: 5.25 in. (13.33 cm)

 

- Cover side (side not facing wall): 1.75 in. (4.44 cm)

 

- Base side (facing wall): 0 in. (0 cm)