Cisco Systems IE 3010 Manual De Usuario

Torque the captive screws (above the wires) to 8.5 in-lb (± 0.5 in-lb).

Connect the other end of the line wire (the one connected to L) to the line terminal on the AC-power 
source, and connect the other end of the neutral wire (the one connected to N) to the neutral terminal on 
the AC power source.

Connect the other end of the positive wire (the one connected to +) to the positive terminal on the 
DC-power source, and connect the other end of the negative wire (the one connected 

 

to –) to the negative terminal on the DC power source.

Close the power-input terminal cover. Use a ratcheting torque screwdriver to torque the screw to 6–8 
in-lb.

Turn on the power at the AC or DC circuit, verify that the PSU1 or PSU2 LED on the switch and PSU 
OK LED on the power-supply module are green. 

If you have two power supplies, repeat Step 1 through Step 11. See the switch software guide for 
information on how to configure the power supply settings.

The power-supply modules are hot-swappable. By removing the power-supply modules, you can power 
off the switch without disconnecting the wiring from the power-input terminal.

We recommend that power be OFF at the AC or DC circuits. Locate the circuit breakers, turn them OFF 
and tape them in the OFF position. 

If the power is not off at the AC or DC circuit breaker, do not touch the power-input terminal.

Verify that the PSU LED and PSU OK LED is blinking red or is off.

Use a Phillips screwdriver to loosen the captive screws that secure the power-supply module to the 
switch. See 

Hot surface. Statement 1079

C isco IE 3010

Sw itch Series

208384