Cisco Systems IE 3010 Manual De Usuario

Look at the port LEDs information when troubleshooting the switch. See the 

for a description of the LED colors and their meanings.

Always examine the cable for marginal damage or failure. A cable might be just good enough to connect 
at the physical layer, but it could corrupt packets as a result of subtle damage to the wiring or connectors. 
You can identify this problem because the port has many packet errors or it constantly flaps (loses and 
regains link).

Exchange the copper or fiber-optic cable with a known good cable.

Look for broken or missing pins on cable connectors.

Rule out any bad patch panel connections or media convertors between the source and the 
destination. If possible, bypass the patch panel, or eliminate media convertors 
(fiber-optic-to-copper).

Try the cable in another port to see if the problem follows the cable.

Make sure that you have the correct cable:

For Ethernet, use Category 3 copper cable for 10 Mb/s UTP connections. Use either Category 5, 
Category 5e, or Category 6 UTP for 10/100 or 10/100/1000 Mb/s connections.

Verify that you have the correct fiber-optic cable for the distance and port type. Make sure that the 
connected device ports match and use the same type encoding, optical frequency, and fiber type.

Determine if a copper crossover cable was used when a straight-through was required or the reverse. 
Enable auto-MDIX on the switch, or replace the cable. See 

 for recommended Ethernet 

cables.

Verify that both sides have link. A broken wire or a shutdown port can cause one side to show link even 
though the other side does not have link.

A port LED that is on does not guarantee that the cable is functional. It might have encountered physical 
stress, causing it to function at a marginal level. If the port LED does not turn on:

Connect the cable from the switch to a known good device.

Make sure that both ends of the cable are connected to the correct ports.

Verify that both devices have power.

Verify that you are using the correct cable type. See 

 for information.

Look for loose connections. Sometimes a cable appears to be seated but is not. Disconnect the cable, 
and then reconnect it.