Cisco Systems IE 3010 Manual De Usuario

To set up the switch, you need to complete the setup program, which runs automatically after the switch 
powers on. You must assign an IP address and other configuration information necessary for the switch 
to communicate with the local routers and the Internet. 

You need this information:

Switch IP address

Subnet mask (IP netmask)

Default gateway (router)

Enable secret password

Enable password

Telnet password

Follow these steps to complete the setup program and to create an initial configuration for the switch:

Enter Yes at these two prompts.

Would you like to enter the initial configuration dialog? [yes/no]: yes

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity

for management of the system, extended setup will ask you

to configure each interface on the system.

Would you like to enter basic management setup? [yes/no]: yes

Enter a host name for the switch, and press Return.

On a command switch, the host name is limited to 28 characters and on a member switch to 31 
characters. Do not use -n, where n is a number, as the last character in a host name for any switch.

Enter host name [Switch]: host_name

Enter an enable secret password, and press Return.

The password can be from 1 to 25 alphanumeric characters, can start with a number, is case sensitive, 
allows spaces, but ignores leading spaces. The secret password is encrypted, and the enable password is 
in plain text.

Enter enable secret: secret_password

Enter an enable password, and press Return.

Enter enable password: enable_password