Cisco Systems SPS224G4 Manual De Usuario
Ethernet Configuration Commands
duplex
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
155
12
Example
The following example configures the speed operation of Ethernet port e5 to 100
Mbps operation.
Mbps operation.
Console(config)# interface ethernet e5
Console(config-if)# speed 100
duplex
The duplex Interface Configuration (Ethernet) mode command configures the full/
half duplex operation of a given Ethernet interface when not using auto-
negotiation. Use the no form of this command to restore the default configuration.
half duplex operation of a given Ethernet interface when not using auto-
negotiation. Use the no form of this command to restore the default configuration.
NOTE
(SPS224G4 combo ports) This command applies when the copper port is used.
The configuration does not apply when an SFP is plugged to the port.
The configuration does not apply when an SFP is plugged to the port.
Syntax
duplex {half | full}
no duplex
Parameters
•
half — Forces half-duplex operation
•
full — Forces full-duplex operation
Default Configuration
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet) mode