Cisco Systems SPS224G4 Manual De Usuario
Ethernet Configuration Commands
mdix
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
160
12
Example
In the following example, flow control is enabled on port 1.
Console(config)# interface ethernet 1
Console(config-if)# flowcontrol on
mdix
The mdix Interface Configuration (Ethernet) mode command enables cable
crossover on a given interface. Use the no form of this command to disable cable
crossover.
crossover on a given interface. Use the no form of this command to disable cable
crossover.
NOTE
(SPS224G4 combo ports) This command applies when the copper port is used.
The configuration does not apply when an SFP is plugged to the port.
The configuration does not apply when an SFP is plugged to the port.
Syntax
mdix {on | auto}
no mdix
Parameters
•
on — Manual mdix is enabled.
•
auto — Automatic mdi/mdix is enabled.
Default Configuration
The default setting is auto.
Command Mode
Interface Configuration (Ethernet) mode