Cisco Systems SPS224G4 Manual De Usuario
Ethernet Configuration Commands
port storm-control broadcast rate
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
176
12
Use the port storm-control include-multicast Global Configuration mode
command to enable counting Multicast packets in the storm control calculation.
command to enable counting Multicast packets in the storm control calculation.
Example
The following example enables Broadcast storm control on port 1 of a device.
Console(config)# interface ethernet 1
Console(config-if)# port storm-control broadcast enable
port storm-control broadcast rate
The port storm-control broadcast rate Interface Configuration (Ethernet) mode
command configures the maximum Broadcast rate. Use the no form of this
command to restore the default configuration.
command configures the maximum Broadcast rate. Use the no form of this
command to restore the default configuration.
Syntax
port storm-control broadcast rate
rate
no port storm-control broadcast rate
Parameters
•
rate
— Maximum kilobits per second of Broadcast and Multicast traffic on a
port. (Range for GE ports: 3500 K–100 M,
range for FE ports: 70 K – 100 M, range for SPS2024 devices: 3.5 M - 1 G)
range for FE ports: 70 K – 100 M, range for SPS2024 devices: 3.5 M - 1 G)
Default Configuration
The default storm control broadcast rate for FE ports is 100 Kbits/Sec and for GE
ports is 500 Kbits/Sec.
ports is 500 Kbits/Sec.
Command Mode
Interface Configuration (Ethernet) mode