Cisco Systems SPS224G4 Manual De Usuario
Introduction
Accessing the Command Line Interface
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
26
1
Figure 6
Command Line
You can now enter CLI commands to manage the Switch. For detailed information
on CLI commands, refer to the appropriate chapter(s) of this Reference Guide.
on CLI commands, refer to the appropriate chapter(s) of this Reference Guide.
Using Telnet over an Ethernet Interface
Telnet provides a method of connecting to the Command Line Interface using TCP/
IP over a standard Ethernet connection. A telnet session can be established in
HyperTerminal or from a command prompt.
IP over a standard Ethernet connection. A telnet session can be established in
HyperTerminal or from a command prompt.
To establish a telnet session from the command prompt, perform the following
steps:
steps:
STEP 1
Click Start, then select All Programs > Accessories > Command Prompt to open a
command prompt.
command prompt.
Figure 7 Start > All Programs > Accessories > Command Prompt
STEP 2
At the prompt, enter telnet 192.168.1.254, then press Enter.