Cisco Systems N3KC3064TFAL3 Manual De Usuario
Purpose
Command or Action
Enables dot1q (IEEE 802.1Q) tagging for all native
VLANs on all trunked ports on the Cisco Nexus 3000
Series switch. By default, this feature is disabled.
VLANs on all trunked ports on the Cisco Nexus 3000
Series switch. By default, this feature is disabled.
switch(config)# vlan dot1q tag
native
native
Step 2
(Optional)
Disables dot1q (IEEE 802.1Q) tagging for all native
VLANs on all trunked ports on the switch.
Disables dot1q (IEEE 802.1Q) tagging for all native
VLANs on all trunked ports on the switch.
switch(config)# no vlan dot1q tag
native
native
Step 3
(Optional)
Displays the status of tagging on the native VLANs.
Displays the status of tagging on the native VLANs.
switch# show vlan dot1q tag native
Step 4
The following example shows how to enable 802.1Q tagging on the switch:
switch#
configure terminal
switch(config)#
vlan dot1q tag native
switch(config)#
exit
switch#
show vlan dot1q tag native
vlan dot1q native tag is enabled
Verifying Interface Configuration
To display access and trunk interface configuration information, perform one of these tasks:
Purpose
Command
Displays the interface configuration
switch# show interface
Displays information for all Ethernet interfaces,
including access and trunk interfaces.
including access and trunk interfaces.
switch# show interface switchport
Displays interface configuration information.
switch# show interface brief
Cisco Nexus 3000 NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)U3(1)
OL-26590-01
57
Configuring Access and Trunk Interfaces
Verifying Interface Configuration