Cisco Systems N3KC3064TFAL3 Manual De Usuario
With the switch configured as the root bridge, do not manually configure the hello time, forward-delay
time, and maximum-age time using the spanning-tree mst hello-time, spanning-tree mst forward-time,
and spanning-tree mst max-age configuration commands.
time, and maximum-age time using the spanning-tree mst hello-time, spanning-tree mst forward-time,
and spanning-tree mst max-age configuration commands.
Note
Procedure
Purpose
Command or Action
Enters configuration mode.
switch# configure terminal
Step 1
Configures a software switch as the primary root bridge.
The vlan-range value can be 2 through 4094 (except
The vlan-range value can be 2 through 4094 (except
switch(config)# spanning-tree vlan
vlan-range root primary [diameter
dia [hello-time hello-time]]
vlan-range root primary [diameter
dia [hello-time hello-time]]
Step 2
reserved VLAN values.) The dia default is 7. The
hello-time can be from 1 to 10 seconds, and the default
value is 2 seconds.
hello-time can be from 1 to 10 seconds, and the default
value is 2 seconds.
This example shows how to configure the switch as the root bridge for a VLAN:
switch#
configure terminal
switch(config)#
spanning-tree vlan 5 root primary diameter 4
Configuring a Secondary Root Bridge
When you configure a software switch as the secondary root, the STP bridge priority is modified from the
default value (32768) so that the switch is likely to become the root bridge for the specified VLANs if the
primary root bridge fails (assuming the other switches in the network use the default bridge priority of 32768).
STP sets the bridge priority to 28672.
default value (32768) so that the switch is likely to become the root bridge for the specified VLANs if the
primary root bridge fails (assuming the other switches in the network use the default bridge priority of 32768).
STP sets the bridge priority to 28672.
Enter the diameter keyword to specify the network diameter (that is, the maximum number of bridge hops
between any two end stations in the network). When you specify the network diameter, the software
automatically selects an optimal hello time, forward delay time, and maximum age time for a network of that
diameter, which can significantly reduce the STP convergence time. You can enter the hello-time keyword
to override the automatically calculated hello time.
between any two end stations in the network). When you specify the network diameter, the software
automatically selects an optimal hello time, forward delay time, and maximum age time for a network of that
diameter, which can significantly reduce the STP convergence time. You can enter the hello-time keyword
to override the automatically calculated hello time.
You configure more than one switch in this manner to have multiple backup root bridges. Enter the same
network diameter and hello time values that you used when configuring the primary root bridge.
network diameter and hello time values that you used when configuring the primary root bridge.
With the switch configured as the root bridge, do not manually configure the hello time, forward-delay
time, and maximum-age time using the spanning-tree mst hello-time, spanning-tree mst forward-time,
and spanning-tree mst max-age global configuration commands.
time, and maximum-age time using the spanning-tree mst hello-time, spanning-tree mst forward-time,
and spanning-tree mst max-age global configuration commands.
Note
Cisco Nexus 3000 NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)U3(1)
OL-26590-01
81
Configuring Rapid PVST+
Configuring a Secondary Root Bridge