Cisco Systems SG50028PK9NA Manual De Usuario

IPv4 Management and Interfaces

272

Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version) 

To configure an IPv6 loopback interface, do the following:

•

In Layer 2, add a loopback interface in the Administration > Management 
Interface > IPv6 Interfaces page. Configure the IPv6 address of that 
interface in the Administration > Management Interface > IPv6 Addresses 
page. This page is not available in SG500X, ESW2-550X and SG500XG 
devices.

•

In Layer 3, add a loopback interface in IP Configuration > IPv6 Management 
and Interfaces > IPv6 Interface. Configure the IPv6 address of that interface 
in the IP Configuration > IPv6 Management and Interfaces > IPv6 Addresses 
page. 

IPv4 interfaces can be defined on the device when it is in Layer 2 or Layer 3 
system mode.

This section is not relevant for the SG500X, ESW2-550X or SG500XG device.

To manage the device by using the web-based configuration utility, the IPv4 
device management IP address must be defined and known. The device IP 
address can be manually configured or automatically received from a DHCP 
server.

To configure the IPv4 device IP address:

Click Administration > Management Interface > IPv4 Interface.

Enter values for the following fields:

•

Management VLAN—Select the Management VLAN used to access the 
device through telnet or the Web GUI. VLAN1 is the default Management 
VLAN.

•

IP Address Type—Select one of the following options:

-

Dynamic

—Discover the IP address using DHCP from the management 

VLAN.