Cisco Systems C3850NM210G Manual De Usuario

This appendix provides a CLI-based setup procedure for a Catalyst 3850 standalone switch or a switch 
stack. To set up the switch by using Express Setup, see the Catalyst 3850 Switch Getting Started Guide. 
Before connecting the switch to a power source, review the safety warnings in 

You can access the CLI on an unconfigured switch by placing the switch in Express Setup mode and 
then connecting a switch Ethernet port or the Ethernet management port to the Ethernet port of your PC 
or workstation. To put the switch into Express Setup mode, follow the steps described in the getting 
started guide for powering on the switch and using Express Setup.

When the switch is in Express Setup mode, open a Telnet session to the switch by entering the IP address 
10.0.0.1. Enter the setup user EXEC command. Enter the information described in the 

After you have entered the configuration information for the switch, save it to flash memory by using 
the write memory privileged EXEC command. 

While in Express Setup mode, the IP address 10.0.0.1 remains active on the switch until you enter the 
write memory

command. You lose the Telnet connection after entering the write memory command.

For more information about using the CLI, see the command reference for this release.