Cisco Systems N3KC3064TQ32T Manual De Usuario
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
3-5
Cisco Nexus 3000 Series Hardware Installation Guide
OL-25338-04
Chapter 3 Connecting to the Network
Connecting to a Server
Note
If you cannot install the cable into the transceiver, insert or leave the dust plug in the cable end
of the transceiver.
of the transceiver.
Replacing an SFP or SFP+ Transceiver
To replace an SFP or SFP+ transceiver, follow these steps:
Step 1
Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 2
If a cable is installed in the transceiver, do the following:
a.
Record the cable and port connections for later reference.
b.
Press the release latch on the cable, grasp the connector near the connection point, and gently pull
the connector from the transceiver.
the connector from the transceiver.
c.
Insert a dust plug into the cable end of the transceiver.
Caution
If the transceiver does not remove easily in the next step, push the transceiver completely in
and then ensure that the latch is in the correct position before continuing.
and then ensure that the latch is in the correct position before continuing.
Step 3
Remove the transceiver from the port as follows:
•
If the transceiver has a Mylar tab latch, gently pull the tab straight out (do not twist), and then pull
the transceiver out of the port.
the transceiver out of the port.
•
If the transceiver has a bale clasp latch, open the clasp by pressing it downward, and then pull the
transceiver out of the port.
transceiver out of the port.
Note
If you have difficulty removing a bale clasp SFP or SFP+ transceiver, you should reseat it by
returning the bale clasp latch to the up position. Press the SFP or SFP+ transceiver inward and
upward into the cage. Next, lower the bale clasp latch and pull the SFP or SFP+ transceiver
straight out with a slight upward lifting force. Be careful not to damage the port cage during this
process.
returning the bale clasp latch to the up position. Press the SFP or SFP+ transceiver inward and
upward into the cage. Next, lower the bale clasp latch and pull the SFP or SFP+ transceiver
straight out with a slight upward lifting force. Be careful not to damage the port cage during this
process.
Step 4
Insert a dust cover into the port end of the transceiver and place the transceiver on an antistatic mat or
into a static shielding bag if you plan to return it to the factory.
into a static shielding bag if you plan to return it to the factory.
Step 5
Install a replacement transceiver (see the
).
If another transceiver is not being installed, protect the optical cage by inserting a clean cover.
Installing Optical Cables into SFP or SFP+ Transceivers
This section includes the following topics:
•
•