Cisco Systems 200 Manual De Usuario

Macro Failure and the Reset Operation

137

Cisco Small Business 200 Series Smart Switch Administration Guide 

•

If the Startup Configuration File specifies a static Smartport type, the 
Smartport type of the interface is set to this static type.

•

If the Startup Configuration File specifies a Smartport type that was 
dynamically assigned by Auto Smartport:

-

If the Auto Smartport Global Operational state, the interface Auto 
Smartport state, and the Persistent Status are all Enable, the Smartport 
type is set to this dynamic type.

-

Else the corresponding anti-macro is applied and the interfaces status is 
set to Default.

A Smartport macro might fail if there is a conflict between the existing 
configuration of the interface and a Smartport macro.

When a Smartport macro fails, a SYSLOG message containing the following 
parameters is sent:

•

Port number

•

Smartport type

•

The line number of the failed CLI command in the macro

When a Smartport macro fails on an interface, the status of the interface is set to 
Unknown. The reason for the failure can be displayed in the Interface Settings 
page, Show Diagnostics popup. 

After the source of the problem is determined and the existing configuration or 
Smartport macro is corrected, you must perform a reset operation to reset the 
interface before it can be reapplied with a Smartport type (in the Interface 
Settings pages). See the workflow area in 

 section for 

troubleshooting tips.