Cisco Systems 2960S Manual De Usuario

For information on the System LED colors during power-on self-test (POST), see the 

The RPS LED is not present on the Catalyst 2960S-F48FPS-L, 2960S-F48LPS-L, 2960S-F24PS-L, 
2960S-F48TS-L, 2960S-F24TS-L, 2960S-F48TS-S, and 2960S-F24TS-S switches—these models do 
not support RPS.

For information about the Cisco RPS 2300, see the 

 section.

The port and module slots each has a port LED. As a group or individually, the LEDs show information 
about the switch and about the ports. 

 lists the mode LEDs and their associated port modes and 

meanings.

Off

RPS is off or not properly connected.

Green

RPS is connected and can provide back-up power.

Blinking green

RPS is connected but is unavailable. It is providing power to another device 
(redundancy has been allocated to the other device).

Amber

The RPS is in standby mode or in a fault condition. See the RPS documentation.

Blinking amber

The power supply in a switch has failed, and the RPS is providing power to the 
switch (redundancy has been allocated to this device).

Off

Switch is not the stack master.

Green

Switch is the stack master or a standalone switch.

Amber

An error occurred when the stack was electing the stack master switch, or another type 
of stack error occurred.

STAT

Port status

The port status. This is the default mode.

DUPLX 

Port duplex

The port duplex mode: full duplex or half duplex.

The ports operate only in full-duplex mode.