Compaq 2724 Manual De Usuario
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-12 Managing the Hub
Writer: Chris Seiter Project: Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide Comments:
File Name:2824_5.DOC Last Saved On: 06/25/97 5:32 PM
HUBNVLE*
*
*
Health
enterpriseSpecific(6):
nSnmpDot3RptrMgt.1
nSnmpDot3RptrMgt.1
rptrBasHealthState, rptrBasHealthText,
rptrBasHealthData, rptrBasID, rptrExtName
rptrBasHealthData, rptrBasID, rptrExtName
Group Change enterpriseSpecific(6):
nSnmpDot3RptrMgt.2
rptrBasGroupMap, rptrBasId, rptrExtName
Reset
enterpriseSpecific(6):
nSnmpDot3RptrMgt.3
nSnmpDot3RptrMgt.3
rptrBasHealthState, rptrBasHealthText,
rptrBasHealthData, rptrBasID, rptrExtName
rptrBasHealthData, rptrBasID, rptrExtName
** RFC1516 traps and HUBNVLE traps are issued under the same circumstances. Because of this, the hub issues traps
from one or the other MIB, but not both. The CPQN2FE MIB variable n2feTrapSupport lets you select which traps are
issued.
from one or the other MIB, but not both. The CPQN2FE MIB variable n2feTrapSupport lets you select which traps are
issued.
The following table describes when the 2824 hub issues each trap. The Health,
Group Change, and Reset traps are listed only once since they are issued under
the same circumstances.
Group Change, and Reset traps are listed only once since they are issued under
the same circumstances.
Traps Issued
Trap
Issued When
Cold Start
Issued when the hub has completed a re-initialization
Authentication Failure
Issued when the hub receives an SNMP request that is not properly authenticated;
usually this indicates an invalid community string
usually this indicates an invalid community string
Rising Alarm
Issued when a monitored MIB object exceeds a specified threshold. The RMON
alarmTable and eventTable must be appropriately configured to enable this trap.
alarmTable and eventTable must be appropriately configured to enable this trap.
Falling Alarm
Issued when a monitored MIB object falls below a specified threshold. The RMON
alarmTable and eventTable must be appropriately configured to enable this trap.
alarmTable and eventTable must be appropriately configured to enable this trap.
Health
Issued when changes occur in the 2824 hub operational state
Group Change
Issued when a unit is added or removed from the stack. The RFC1516 trap provides
the unit number whose status changed. In the HUBNVLE trap, a 16-bit bitmap shows
which units are currently present in the stack; the least significant bit represents unit
1.
the unit number whose status changed. In the HUBNVLE trap, a 16-bit bitmap shows
which units are currently present in the stack; the least significant bit represents unit
1.
Reset
Issued after completion of a reset initiated by rptrReset or rptrBasReset