Compaq 2724 Manual De Usuario
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B-2 Using the VT100 Interface
Writer: Chris Seiter Project: Compaq Netelligent 2724/2824 Dual-Speed Hub User Guide Comments: 299440-001
File Name:2824_B.DOC Last Saved On:6/23/97 5:26 PM
Starting the VT100 Interface
After you make the required connections and set up the communications
program, follow these steps to start the VT100 interface.
program, follow these steps to start the VT100 interface.
NOTE: The VT100 interface allows only one active user at a time. For example, if an
active VT100 session is using Telnet over Ethernet, another session cannot occur
over the serial or Ethernet connections.
1.
Start the communications program. If you use a Telnet application, enter a
valid IP address and start the connection.
valid IP address and start the connection.
2.
Enter the following command:
vt100
NOTE: If the login fails, you may need to retry the connection several times.
The Login screen appears.
Figure B- 1. Login Screen
3.
Within 20 seconds after the Login screen appears, enter the password. The
default password is
default password is
public. The Main menu screen appears.